Yes, you can. Please pay attention to the fact that the blade has a specific angle. If the angle will occur to be too obtuse or too acute, this can cause possible damage to the tool.
Cutter of HCT-40 and HCT-55 made by KBT are designed for cutting different solid materials so that the user can easily change the blades when necessary. HC cutter is designed so that in 90% when you face a break of blades it means that the ratchet also needs to be changed. This leads to an almost full disassembly of the tool. This specific task should be done by professionals from KBT Service Center.
The figures in names mean the maximum diameter of stranded alum cable, that can be cut with this tool. For example, HC-45 cutter is designed for cutting a cable with a diameter of 45 mm. It is important that for cutting of solid cable of the same diameter you should choose a tool with a bigger cutting potential.
It depends on the type of material, the hardness of blades and the sharpening angle. In most cases, hard materials such as steel ropes and bars should be cut with blades of extra hardness and with a specific sharpening angle. Cable with steel armoring should be cut with very sharp and not hard blades.
Hydraulic cutter is easier to work with, so the main difference is, of course, comfort. In most cases, hydraulic cutters are designed for cutting various copper and alum cables, steel ropes, stranded ropes, and ACSR. A typical sample of this kind of cutter is models made by KBT: НГР-40, НГР-53, НГР-65, НГР-85. Most hydraulic cutters have a guillotine-type working head that has a big operational resource. Mechanical models of cutters can be of smaller size, thus more compact. One more advantage of mechanical models is that you can work with them in almost all weather conditions. At the same time that demands much care, as small particles in the ratchet can cause a break.
These are technological holes. They are used for fixation of blades during treatment: sharpening or polishing. In some models, they are designed to make the total weight of the cutter less.
All kinds of works should be done on a disconnected line. If the cutting under voltage is really necessary you should use tools with insulated handles, that are designed for work under voltage. This possibility should be indicated in the tool manual.






